Pentens® T-009 is a PMMA – silylated polymethylmethacrylate resin based coating of good hardness, adhesion, wear resistant, scratch resistant, UV resistant, anti-corrosive sealer, primer & finish for a wide variety of exterior and interior surfaces.

Uses:
Interior / Exterior applicable surfaces are
including:
- Concrete
- Plaster
- Metal
- Stone
- Glass
- Tile

 

Areas of use are such as:
- Bonding agent / Primer
- Clear / pigmented industrial floor coating
- Clear / pigmented sealer (mix with filler / aggregate)
- Clear / pigmented outdoor sports floor coating
- Clear / pigmented car park floor coating

Advantages:

  • Excellent adhesion to dry / wet inorganic substrate
  • High resistance to weathering and blistering
  • Excellent color retention
  • Extremely low VOC
  • Easy clean-up using water

Surface Preparation
Surface must be clean, smooth, dry, and free of wax, grease, oil, loose or peeling paint, and other foreign material.

Bonding Agent / Primer
For better permeability and workability, PENTENS T-009 must be mixed with water on 1:3 ratio homogeneously prior to application, Applied by using roller / brush / squeeze / spray equipment.

Clear Coating
Use diluted PENTENS T-009 as a primer & sealer, followed by two coats finish. To dilute T-009 with pure water on 1:3 ratio homogeneously, and applied to the prepared surface by using brush or lamb wool roller or spray equipment.

The second coat may be applied as soon as the first coat has initially dried (typically 4 to 6 hours). The time will be dependent on the type of surface and the ambient conditions.

Pigmented Coating
Use diluted clear PENTENS T-009 as a primer & sealer, followed by two coats pigmented finish. Or to mix clear T-009 with 5~10% compatible water-base pigment paste homogenous and applied to the prepared surface by using brush or lamb wool roller or spray equipment.
The second coat may be applied as soon as the first coat has initially dried (typically 4 to 6 hours). The time will be dependent on the type of surface and the ambient conditions.
PENTENS T-009 can be also added with fine silica sand to be an anti-slip surface.

Precautions for use
- The application and drying temperature must be between 100C and 350C.
- Do not apply to heavy duty industrial floor.

Coverage
Bonding agent / Primer: Approximately 6~10 square meters per kg, depending on the porosity of the substrate.
Clear coating: Approximately 3~5 square meters per kg, depending on the porosity of the substrate. Pigmented Coating: Approximately 1~2 square meters per kg, depending on the porosity of the substrate.

Safety
PENTENS T-009 is non-toxic. For personal precautions, applicators are recommended to wear gloves and goggles when handling PENTENS T-009.