Pentens® E-10 is a reactive two-component system, consisting of modified phenol-type epoxy resin (A-Comp.) and water-emulsified epoxy resin hardener (B-Comp.). This system could actually be formulated using water as a carrier and produces film with outstanding appearance.
Pentens® E-10 is safe for use in sensitive areas and it is environmentally friendly with extremely low V.O.C. (volatile organic compound).

Uses:
- As a primer for water-based waterproofing/
flooring works
- As a binder / sealer for fiber glass mat in tank
lining works
- New and old concrete bonding agent
- Multi-purpose adhesive

Advantages:

  • Environmentally friendly.
  • Can be applied to damp surfaces.
  • Can be safely applied to freshly laid hardened
    (green) concrete.
  • Negligible odor and toxicity.
  • Has excellent adhesion to most substrates,
    including brick, masonry, concrete, compressed
    fiberboard, stone and timber.

Surface Preparation
All surfaces to be treated must be structurally sound and all previous coatings, adhesives, efflorescence or laitance should be removed by chipping, abrasive blast cleaning, high-pressure water washing, mechanical scrubbing or other suitable means.

Dry surfaces should be sprayed with a fine mist of water prior to the application of the PENTENS E-10.

Mixing
PENTENS E-10 A/B must be mixed homogeneously prior to application with an electrical or pneumatic power stirrer at approximately 300 - 400 rpm. (Mixing time is approximately 3-4 minutes depending on circumstances as it may take a longer time to achieve a homogeneous mix in certain circumstances.)

Application
Spread the material using a roller, brush or spray at an approximate rate of 0.2kg/m2 to achieve a smooth coverage and finish.

Wait for 8 hours to cure before applying topping.

Coverage Rate:
Each coat is applied by roller at 0.2kg/m2. Coverage depends on surface porosity and substrate conditions.

IMPORTANT NOTES:

  1. Natural cross-flow ventilation should be adequate.
  2. When PENTENS E-10 is used as a primer, never add more than 5% of water to dilute PENTENS E-10.

Safety
PENTENS E-10 may cause irritation. Gloves and protective goggles must be worn during application and use. Avoid direct contact with skin, eyes and avoid breathing in vapor. Wear protective gloves when mixing or applying it. If swallowed, do not induce vomiting but quickly seek medical advice. If contact with skin occurs, remove contaminated clothing and wash for a minimum of 15 minutes or seek medical advice if symptom persists.